Toshiba Air Conditioner Leaking Water, Causes and Fixes

A Toshiba air conditioner leaking water from the indoor unit is one of the most common problems we see, especially in humid Sydney summers.

In most cases, the cause is a blocked or poorly sloped drain rather than a serious fault. Still, water near electrics and walls needs prompt attention. This page explains why leaks happen and how to stop them.

Where does the water come from?

In cooling and dry modes, the indoor coil runs cold, and moisture in the room air condenses on it, much like water forming on a cold drink. That water drips into a tray beneath the coil and flows out through a drain hose to the outside or to a drain point. On a humid day, a wall split can remove a surprising amount of water.

As long as the drain flows freely, you never see that water. Problems start when it cannot escape.

What should you do straight away?

When you notice water dripping from the indoor unit, act quickly.

  1. Turn the unit off with the remote to stop more water forming.
  2. Place towels or a container under the drip.
  3. Move furniture, electronics and valuables away from the area.
  4. If water drips near power points or electrical items, switch off the power to the air conditioner at the breaker.
  5. Book a technician.

Avoid running the unit in cooling until someone has checked the drain. If you must cool the room in the meantime, a fan or closed blinds will help, and running the air conditioner in fan only mode produces no water at all, so it will not add to the leak.

What usually causes a Toshiba air conditioner leaking water?

The causes we see most often include the following.

  • Drain hoses blocked by dust, slime, insects or mould.
  • Trays clogged with debris.
  • A drain hose that sags, kinks or slopes uphill somewhere along its run.
  • An indoor unit that is not level, so water runs to the wrong end of the tray.
  • Ice on the coil that melts faster than the drain can cope.
  • A cracked drain tray or a loose hose connection.
  • Very dirty filters causing excessive condensation and icing.

Blocked drains account for most leaks we attend.

Why do drains block?

The drain carries water mixed with dust that slips past the filters. In warm, damp conditions, that dust feeds slime and mould, which slowly coat the inside of the tray and hose. Insects and spiders sometimes crawl into the outlet end of the hose and nest there. Over months, the passage narrows until water backs up.

Homes with pets, nearby roadworks or long periods of cooling tend to see drain blockages sooner.

How does a sagging drain hose cause leaks?

Condensate drains rely on gravity, so the hose must slope downward all the way from the indoor unit to the outlet. If a section sags and then rises, water collects in the low point and can back up into the tray. Hoses inside walls or behind cladding can shift over time. Similarly, a hose that ends in a garden bed may become buried and blocked.

Can ice cause water leaks?

Yes. When the indoor coil freezes, ice builds up across the fins. Once the unit stops or the ice melts, a large amount of water arrives in the tray at once. The drain may not keep up, and water spills over the front of the unit. In this case, the real problem is the freezing, so the technician also looks at filters, airflow and refrigerant. Our freezing up page explains the causes.

Why does water spray from the louvres?

Occasionally, water droplets blow out of the louvres with the air. That can happen when water collects inside the unit, such as in a full tray, and the fan picks it up. It can also happen when the coil is very cold and humid air condenses on the louvres themselves. A blocked drain or a dirty coil usually sits behind it.

Is water from the outdoor unit a problem?

In heating mode, water dripping from the outdoor unit is normal melt water from defrost. In cooling mode, the outdoor unit should stay mostly dry. Drips near the outdoor unit in summer may come from the indoor drain hose ending there, or from pipes sweating where insulation has broken down. Neither is usually serious, but damaged insulation is worth fixing.

How much water does a wall split remove?

On a hot, humid Sydney day, a wall split running in cool mode can remove several litres of water from the air over a few hours. The exact amount depends on the room size, humidity and how long the unit runs. That volume explains why even a partly blocked drain soon causes a visible leak. Water that cannot escape has nowhere to go but out the front of the unit.

Why do leaks often start at the beginning of summer?

During winter and spring, the unit runs mostly in heating or not at all, so the drain sits dry. Dust and insects settle in the tray and hose during that time. Then, on the first hot, humid days of summer, cooling produces a sudden flow of water, which meets the blockage. As a result, many leaks appear in the first weeks of summer. A spring service clears the drain before that rush.

What does a gurgling sound mean?

Gurgling from the indoor unit or the wall behind it often means water and air are fighting their way through a partly blocked or poorly sloped drain. It can also come from refrigerant moving through pipes, which is normal. If gurgling comes with dripping or damp patches, the drain is the likely culprit. Our making noise page explains other sounds.

Can a leak damage walls and floors?

Yes. Water running down an internal wall can stain paint, swell plasterboard and encourage mould. On timber floors, water can cause swelling and marks, while carpet can develop odours. In apartments, leaks can even reach neighbours below. That is why prompt action matters, even when the drip seems small.

Does the unit need to be perfectly level?

Wall units should sit level or tilt very slightly toward the drain outlet side, according to the installation instructions. If the unit tilts the wrong way, water runs to the opposite end of the tray and spills over. Brackets can shift over time, particularly on older plasterboard walls. The technician checks the level and adjusts the mounting if needed.

What about mould in the tray?

Slime and mould in the drain tray contribute to both blockages and smells. During a service, the technician cleans the tray and may treat it with a product that slows regrowth. Keeping filters clean also limits the dust that feeds mould. Our bad smell page explains how mould affects air quality and comfort.

Can you clear the drain yourself?

Sometimes you can see the outlet end of the drain hose outside. If it is clearly blocked by mud, leaves or a spider web, gently clearing that end may help. However, avoid pushing wire or tools up the hose, since you can damage it or push the blockage further in. Never open the indoor unit or pour chemicals into it.

For anything beyond clearing the visible outlet, book a technician.

Are apartment drains different?

In apartments, indoor unit drains often run into internal plumbing, such as a waste pipe or a balcony drain, rather than straight outside. Those connections can block or develop smells if they lack a proper trap. Also, long internal runs give more room for sags and blockages. Strata rules may affect where drains can run, so the technician considers those when fixing a recurring leak.

What if the leak only happens in dry mode?

Dry mode removes moisture with gentle cooling, so it produces condensate just like cool mode. If a leak appears mainly in dry mode, the cause is still usually the drain. However, very low fan speeds in dry mode can sometimes let water collect unevenly on the coil and drip from the edges of the tray. A clean coil and a clear drain usually solve it.

Can the wrong drain hose size cause problems?

Yes, occasionally. Installers sometimes extend the original drain hose with a narrower or poorly joined section, which slows the flow and traps debris. If the technician finds an unsuitable joint or a reduced diameter section, replacing it with the correct hose usually stops repeat blockages.

How does a technician fix the leak?

The technician starts by checking the drain path, from the tray to the outlet. They clear the hose with suitable tools or a vacuum pump, clean the tray and treat it to slow slime growth. Then they check the hose slope along its visible length and confirm the indoor unit sits level. Finally, they pour water into the tray to make sure it drains freely.

If the tray has cracked or the hose connection has failed, they replace the faulty part.

What if the leak keeps coming back?

Repeat leaks usually point to a deeper issue, such as a hose with a hidden sag inside a wall, a unit mounted slightly off level or a coil that keeps freezing. In those cases, the technician may need to reroute part of the hose, adjust the mounting or fix the airflow or refrigerant problem behind the freezing.

What about units with condensate pumps?

Some indoor units sit where gravity drainage is not possible, so installers fit a small condensate pump to lift the water. If the pump fails, water backs up quickly. A pump failure often shows as a sudden leak after years of trouble free operation. The technician can test and replace the pump.

Can water damage the electronics?

It can. Water that overflows inside the unit may reach the indoor board or fan motor, which can lead to codes such as 12 or 11. That is why switching the unit off promptly matters. If a leak has already caused a code, the technician will check the electronics as well as the drain.

How can you prevent leaks?

Clean filters regularly so dust does not reach the coil and drain. Book a yearly service, which includes clearing and treating the drain. Keep the outlet end of the hose clear of soil, mulch and plants. If you notice gurgling, a damp patch on the wall or water stains below the unit, book a check early. Our service page explains what a service covers.

How long does a leak repair take?

Most drain clears and tray cleans finish in one visit. Rerouting a hose or replacing a pump or tray may take longer, depending on access. The technician explains the time frame once they have found the cause.

What should you share when booking?

Tell us where the water appears, how much, in which mode and whether it started suddenly. Mention any ice you saw, gurgling noises or recent wall or garden work. Include the model from the indoor unit label.

Who fixes Toshiba air conditioners leaking water in Sydney?

We fix Toshiba air conditioners leaking water across Sydney. To book, phone 02 9071 1142 or use our booking page. The technician will clear the drain, find any underlying cause and explain what they did. If you rent, let your agent know about the booking so access and approval run smoothly. Older units often still respond well to a careful repair, so age alone is not a reason to replace a system.

Frequently asked questions

Why is my Toshiba air conditioner leaking water?

A blocked or poorly sloped drain is the most common cause, followed by ice melting on the coil.

What should I do when it leaks?

Turn the unit off, catch the water, move valuables away and book a technician.

Can I clear the drain myself?

You can clear a visibly blocked outlet outside. Leave anything further to a technician.

Is water from the outdoor unit normal?

In heating mode, yes. In cooling mode, it may come from the drain outlet or sweating pipes.

Can a leak damage the unit?

Yes. Water can reach the board or fan motor, so switch off promptly.

How do I book?

Phone 02 9071 1142 with the model and where the water appears.

{“@context”:”https://schema.org”,”@type”:”HVACBusiness”,”@id”:”https://toshiba.sydneyaircare.com.au/#business”,”name”:”Sydney Air Care, Toshiba Service”,”url”:”https://toshiba.sydneyaircare.com.au/”,”description”:”Toshiba split and ducted air conditioner repair, service and troubleshooting across Sydney. Independent service provider, not affiliated with Toshiba.”,”areaServed”:[{“@type”:”City”,”name”:”Sydney”},{“@type”:”State”,”name”:”New South Wales”}],”parentOrganization”:{“@type”:”Organization”,”name”:”Sydney Air Care”,”url”:”https://sydneyaircare.com.au/”},”telephone”:”+61 2 9071 1142″} {“@context”:”https://schema.org”,”@type”:”FAQPage”,”mainEntity”:[{“@type”:”Question”,”name”:”Why is my Toshiba air conditioner leaking water?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”A blocked or poorly sloped drain is the most common cause, followed by ice melting on the coil.”}},{“@type”:”Question”,”name”:”What should I do when it leaks?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Turn the unit off, catch the water, move valuables away and book a technician.”}},{“@type”:”Question”,”name”:”Can I clear the drain myself?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”You can clear a visibly blocked outlet outside. Leave anything further to a technician.”}},{“@type”:”Question”,”name”:”Is water from the outdoor unit normal?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”In heating mode, yes. In cooling mode, it may come from the drain outlet or sweating pipes.”}},{“@type”:”Question”,”name”:”Can a leak damage the unit?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Yes. Water can reach the board or fan motor, so switch off promptly.”}},{“@type”:”Question”,”name”:”How do I book?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Phone 02 9071 1142 with the model and where the water appears.”}}]}
Call 02 9071 1142